It helps if you actually publish the post rather than leave it as a draft! So, following on from my last post I have continued with the wiring. This is one area I have really been looking forward to. its probably my favourite subject.

As I said previously I wanted to make the loom once if possible so a few nights have been spent drawing out all the additional circuits, removing unwanted wiring and planning the physical fit.

I started with the engine loom. This needed physically mounting so I came up with:

I plan to move the diagnostic socket to the boot area (this will make sense in time!) so those wires will go. The starter lead will also move so the under bonnet area should look pretty tidy.